Case IH Tractor ECU Solutions: Bosch MD1CS069, EDC7UC31 and EDC17C49
With FPT-engined Puma, Maxxum and Farmall series, Case IH tractors are among the hardest-working machines in the field. Depending on model year, the engine is managed by different Bosch ECU families. Solutions for Case IH are available at ECU Prime across a wide range of Bosch and Cummins ECUs.
Which ECU does your Case IH use?
- Bosch MD1CS069: on new Stage V models. Stage 1, AdBlue / SCR, EGR, emission package and combined Stage 1 + AdBlue files.
- Bosch EDC7UC31: on previous-generation models. Stage 1, emission package and Stage 1 + AdBlue.
- Bosch EDC17C49: Stage 1, AdBlue, DPF, EGR and emission package.
- Bosch EDC17CV41 and MD1CE101: Stage 1, AdBlue and emission package.
- Bosch EDC16C39, EDC16, Cummins CM554 and CM850: Stage 1; older models are covered too.
The ECU type depends on model year and engine. The exact type is confirmed from the ECU label or by reading it with a diagnostic tool; send a photo of the label on WhatsApp and we will tell you which file applies.
Common faults
- AdBlue / SCR warning and derate
- DPF loading and endless regeneration
- Sooted EGR valve and warning lamp
- Torque drop under heavy load
See our Case IH page and Case IH AdBlue fault solution.
How it works
- Reading: upload the original file read with your tool, or visit one of our locations.
- Calibration: the file is prepared for the exact engine and ECU software version, checksum corrected; the original is archived.
- Application and check: fault scan and run / road test after writing.
Workshops get the same solutions through the ECU Prime file service.
Emission-related software is offered only for uses permitted by applicable law (off-road / closed-site use, racing, export, diagnostics); road use and inspection compliance are the owner’s responsibility.