Manitou ECU Solutions: AdBlue, DPF, EGR and Stage 1 on Bosch MD1CC878 and EDC17C49
Manitou telehandlers are among the hardest-working machines on building sites, farms and in warehouses. On new Stage V models, AdBlue, DPF and EGR faults force the machine into derate or limp mode. Solutions for Manitou are available at ECU Prime on these Bosch ECU families.
Which ECU does your Manitou use?
- Bosch MD1CC878: found on new-generation Deutz-engined Stage V machines (telehandlers such as the MT 1840). An emission package (AdBlue / DPF / EGR) is available for Manitou.
- Bosch EDC17C49: the largest Manitou group: Stage 1, AdBlue / SCR, emission package and combined Stage 1 + DPF + EGR + AdBlue files.
- Bosch EDC17CV45: DPF solution available.
The ECU type depends on model year and engine. The exact type is confirmed from the ECU label or by reading it with a diagnostic tool; send a photo of the label on WhatsApp and we will tell you which file applies.
Same ECU, different machine: Deutz-Fahr
The MD1CC878 also appears on Deutz-Fahr tractors with the same Deutz engine family, where Stage 1, AdBlue, DPF and EGR solutions are available too.
See our Manitou page and Manitou AdBlue fault solution.
How it works
- Reading: upload the original file read with your tool, or visit one of our locations.
- Calibration: the file is prepared for the exact engine and ECU software version, checksum corrected; the original is archived.
- Application and check: fault scan and run / road test after writing.
Workshops get the same solutions through the ECU Prime file service.
Emission-related software is offered only for uses permitted by applicable law (off-road / closed-site use, racing, export, diagnostics); road use and inspection compliance are the owner’s responsibility.