Terex and Atlas ECU Solution: AdBlue, DPF, EGR and Stage 1
Terex and Germany’s Atlas are common in municipal work and scrap yards with their wheeled excavators and material handlers. Solutions for both brands are available at ECU Prime on Bosch and Continental ECUs.
Which ECU, which operation?
- Terex, Bosch EDC17CV52: AdBlue / SCR, DPF and EGR.
- Atlas, Bosch EDC17C81: Stage 1, emission package and Stage 1 + emissions.
- Atlas, Continental CM2250: AdBlue / SCR and DPF.
The ECU type depends on model year and engine. The exact type is confirmed from the ECU label or by reading it with a diagnostic tool; send a photo of the label on WhatsApp and we will tell you which file applies.
Common faults
- AdBlue / SCR warning and derate
- DPF loading and frequent regeneration after long idling
- Sooted EGR valve and warning lamp
- Torque drop under load
Related pages: Terex, Terex AdBlue fault solution, Atlas, Atlas AdBlue fault solution.
How it works
- Reading: upload the original file read with your tool, or visit one of our locations.
- Calibration: the file is prepared for the exact engine and ECU software version, checksum corrected; the original is archived.
- Application and check: fault scan and run / road test after writing.
Workshops get the same solutions through the ECU Prime file service.
Emission-related software is offered only for uses permitted by applicable law (off-road / closed-site use, racing, export, diagnostics); road use and inspection compliance are the owner’s responsibility.