Renault Megane · 2008+
Renault Megane DPF Fault Solution
When the DPF (diesel particulate filter) clogs on Renault Megane (2008+) diesel engines, the car regenerates frequently, power is limited and a warning lamp comes on. Differential pressure and fault memory are checked first, the ECU is identified and a matching software solution is applied after an original backup.
Suitable engines for the Renault Megane
Year / chassis: 4 LCI - 2020+
| Engine | Power | DPF fault solution |
|---|---|---|
| Renault Megane 1.5 Blue dCi 115hp | 115 → 144 bhp | ✓ |
Year / chassis: 4 - (ph1) - 2016 - 2019
| Engine | Power | DPF fault solution |
|---|---|---|
| Renault Megane 1.5 dCi 110hp | 110 → 135 bhp | ✓ |
| Renault Megane 1.5 dCi 115hp | 115 → 135 bhp | ✓ |
| Renault Megane 1.5 dCi 90hp | 90 → 110 bhp | ✓ |
| Renault Megane 1.5 dCi 95hp | 95 → 110 bhp | ✓ |
| Renault Megane 1.6 dCi 130hp | 130 → 155 bhp | ✓ |
| Renault Megane 1.6 dCi 165hp | 165 → 180 bhp | ✓ |
| Renault Megane 1.7 Blue dCi 150hp | 150 → 180 bhp | ✓ |
Year / chassis: 3 - (ph3) - 2013 - 2015
| Engine | Power | DPF fault solution |
|---|---|---|
| Renault Megane 1.5 DCi 110hp | 110 → 130 bhp | ✓ |
| Renault Megane 1.5 DCi 95hp | 95 → 115 bhp | ✓ |
| Renault Megane 1.6 DCi 130hp | 130 → 160 bhp | ✓ |
| Renault Megane 2.0 DCi 165hp | 165 → 195 bhp | ✓ |
Year / chassis: 3 - (ph2) - 2012 - 2013
| Engine | Power | DPF fault solution |
|---|---|---|
| Renault Megane 1.5 DCi 110hp | 110 → 130 bhp | ✓ |
| Renault Megane 1.5 DCi 90hp | 90 → 110 bhp | ✓ |
| Renault Megane 1.6 DCi 130hp | 130 → 160 bhp | ✓ |
Year / chassis: 3 - (ph1) - 2008 - 2012
| Engine | Power | DPF fault solution |
|---|---|---|
| Renault Megane 1.5 DCi 106hp | 106 → 130 bhp | ✓ |
| Renault Megane 1.5 DCi 110hp | 110 → 120 bhp | ✓ |
| Renault Megane 1.5 DCi 85hp | 85 → 105 bhp | ✓ |
| Renault Megane 1.5 DCi 90hp | 90 → 110 bhp | ✓ |
| Renault Megane 1.6 DCi 130hp | 130 → 160 bhp | ✓ |
| Renault Megane 1.9 DCi 130hp | 130 → 165 bhp | ✓ |
| Renault Megane 2.0 DCi 150hp | 150 → 180 bhp | ✓ |
| Renault Megane 2.0 DCi 160hp | 160 → 190 bhp | ✓ |
When is it needed?
- DPF full / regeneration warning
- Frequent regeneration and rising fuel use
- Engine warning light and reduced power
- Oil dilution and a costly DPF replacement
Typical duration: 1–2 hours
Frequently asked questions
Can a clogged DPF on the Renault Megane be solved with software?
The filter and sensors are checked first; any mechanical fault is reported. Where suitable for the Renault Megane, the DPF software solution is applied to the ECU with the original software backed up and verified by a road test.
Will the car pass inspection after a DPF delete?
Work on emission hardware can affect inspection and road compliance. This work is offered only for uses permitted by law, such as off-road, motorsport, export or fault diagnosis. Inspection and road compliance remain the owner's responsibility.
Does the filter have to be physically removed?
We handle the software side; physical work on the filter is done in the workshop depending on the car and your choice. If only software is changed and the filter stays in place, it will keep loading up.
Should I try cleaning first?
In most cases yes. If the filter is not yet blocked, a forced regeneration or chemical clean is the better step; we measure the condition and tell you the cheapest route.
Will fuel consumption drop?
On a car that regenerates frequently it usually does, because the extra fuel burned during regeneration cycles disappears.
Other solutions for the Renault Megane
Renault Megane AdBlue fault solution
Renault Megane EGR fault solution
Renault Megane Pop & Bang tuning
More about DPF Delete
Renault Stage 1 Chip Tuning — How Much BHP?
⚠ Software work on emission systems is offered only for uses permitted by applicable law (motorsport, off-road use, export, fault diagnosis, etc.). Road use and inspection compliance of the vehicle remain the owner's responsibility.