Cadillac ATS 2013+ 2.5i - 202hp Stage 1 Chip Tuning · ECU Remap
Catalog reference — not a measured result for this vehicle.
Catalog reference: power 202 → 225 bhp, difference +23 bhp (11%); torque 259 → 280 Nm. Actual results depend on vehicle condition and measurement.
Figures are typical ranges; exact results depend on the vehicle's hardware and dyno measurement.
Get a Quote
Cadillac ATS 2013+ 2.5i - 202hp
Book an appointment Find a centreReversible: Yes, the original software is kept
Cadillac ATS 2013+ 2.5i - 202hp — Stage 1 Remap
Stage 1 re-calibrates the ECU software — boost, fuelling and ignition maps — within the factory hardware's safe tolerances. No hardware changes are required.
Stage 1 Remap
Software that optimises the engine's power and torque maps within safe limits.
Stage 2 Remap
Advanced software matched to hardware upgrades such as a sport exhaust or induction kit.
Pop & Bang
Software that creates exhaust crackle on lift-off.
Speed Limiter (Vmax) Removal
Removing the factory top-speed limiter from the software.
DTC / Fault Code Removal
Switching off selected diagnostic trouble codes (DTC) in the ECU software.
Where can this be done near you?
Prime Chiptuning applies the software at its own centres in Türkiye. Abroad, our partners carry out the work with the same files, and workshops can order the file directly.
About the naturally aspirated petrol engine
This vehicle uses a naturally aspirated petrol engine, without a turbo or supercharger. The amount of air it can draw in is physically limited; power depends mainly on displacement, revs and the intake and exhaust design.
How a Stage 1 remap works on the Cadillac ATS 2.5i - 202hp
On naturally aspirated engines the gain from a Stage 1 remap is limited compared with turbo engines. Ignition timing, fuel maps, throttle response and, where useful, the rev limit are optimised for a livelier response and a smoother power curve. Bigger gains need hardware changes such as intake, exhaust or camshafts.
Pre-remap checklist
- Spark plugs, coils and fuel quality.
- Air filter, throttle body and intake leaks.
- Lambda probe and catalytic converter condition.
- Engine compression and oil consumption (at high mileage).
Expectations on naturally aspirated engines should be realistic; catalogue figures are a typical range.
This section is based on Prime Chiptuning workshop experience; the power and torque figures come from the catalogue measurement above.
ECUs used in Cadillac vehicles
If you know your ECU family, its page lists exactly which solutions are available for it.
Cadillac ATS — Power Calculator
| Engine | Power | Gain |
|---|---|---|
| 2.0 Turbo 276hp | 276 → 300 bhp | +24 bhp |
| 3.6 V6 321hp | 321 → 350 bhp | +29 bhp |
| 3.6 V6 335hp | 335 → 350 bhp | +15 bhp |
| 3.6 V6 480hp | 480 → 510 bhp | +30 bhp |