BMW 3 Series E90/E91 - 2005 - 2010 325i - N52 - 211hp Stage 1 Chip Tuning · ECU Remap
Catalog reference — not a measured result for this vehicle.
Catalog reference: power 211 → 232 bhp, difference +21 bhp (10%); torque 250 → 275 Nm. Actual results depend on vehicle condition and measurement.
Figures are typical ranges; exact results depend on the vehicle's hardware and dyno measurement.
Get a Quote
BMW 3 Series E90/E91 - 2005 - 2010 325i - N52 - 211hp
Book an appointment Find a centreReversible: Yes, the original software is kept
BMW 3 Series E90/E91 - 2005 - 2010 325i - N52 - 211hp — Stage 1 Remap
Stage 1 re-calibrates the ECU software — boost, fuelling and ignition maps — within the factory hardware's safe tolerances. No hardware changes are required.
BMW 325i Stage 1: all generations →
Stage 1 Remap
Software that optimises the engine's power and torque maps within safe limits.
Stage 2 Remap
Advanced software matched to hardware upgrades such as a sport exhaust or induction kit.
Pop & Bang
Software that creates exhaust crackle on lift-off.
Speed Limiter (Vmax) Removal
Removing the factory top-speed limiter from the software.
DTC / Fault Code Removal
Switching off selected diagnostic trouble codes (DTC) in the ECU software.
Where can this be done near you?
Prime Chiptuning applies the software at its own centres in Türkiye. Abroad, our partners carry out the work with the same files, and workshops can order the file directly.
About the BMW naturally aspirated six-cylinder (N52 / N53: 323i, 325i, 328i, 330i, 523i, 525i, 530i, 2004–2012)
The naturally aspirated 2.5 and 3.0-litre six-cylinders of the pre-turbo era powered the E90 3 Series, E60 5 Series, E63, Z4 and X3 from 177 to 272 hp. They are smooth, rev-happy engines.
How a Stage 1 remap works on the BMW 3 Series E90/E91 325i - N52 - 211hp
On a naturally aspirated engine Stage 1 re-tunes ignition advance, fuelling, Valvetronic and throttle maps; without a turbo the gain is measured, but throttle response and top-end fullness improve clearly. The speed limiter and rev limit can be addressed in the same calibration if wanted.
Pre-remap checklist
- Valvetronic motor and eccentric shaft sensors.
- Oil filter housing and valve cover gasket leaks (known issue).
- Electric water pump and thermostat.
- Ignition coils and spark plugs.
This section is based on Prime Chiptuning workshop experience; the power and torque figures come from the catalogue measurement above.
ECUs used in BMW vehicles
If you know your ECU family, its page lists exactly which solutions are available for it.
BMW 3 Series — Power Calculator
| Engine | Power | Gain |
|---|---|---|
| 316D 115hp | 115 → 180 bhp | +65 bhp |
| 316i 122hp | 122 → 136 bhp | +14 bhp |
| 318D 122hp | 122 → 155 bhp | +33 bhp |
| 318D 136hp | 136 → 180 bhp | +44 bhp |
| 318D 143hp | 143 → 180 bhp | +37 bhp |
| 318i 143hp | 143 → 157 bhp | +14 bhp |
| 320D 150hp | 150 → 200 bhp | +50 bhp |
| 320D 163hp | 163 → 215 bhp | +52 bhp |
| 320D 177hp | 177 → 214 bhp | +37 bhp |
| 320i 150hp | 150 → 175 bhp | +25 bhp |
| 320i 163hp | 163 → 175 bhp | +12 bhp |
| 320i 170hp | 170 → 182 bhp | +12 bhp |