Peugeot 2008 · 2013+
Peugeot 2008 DPF Fault Solution
When the DPF (diesel particulate filter) clogs on Peugeot 2008 (2013+) diesel engines, the car regenerates frequently, power is limited and a warning lamp comes on. Differential pressure and fault memory are checked first, the ECU is identified and a matching software solution is applied after an original backup.
Suitable engines for the Peugeot 2008
Year / chassis: 2019+
| Engine | Power | DPF fault solution |
|---|---|---|
| Peugeot 2008 1.5 BlueHDi 100hp | 100 → 140 bhp | ✓ |
| Peugeot 2008 1.5 BlueHDi 130hp | 130 → 155 bhp | ✓ |
Year / chassis: 2016 - 2019
| Engine | Power | DPF fault solution |
|---|---|---|
| Peugeot 2008 1.5 BlueHDI 100hp | 100 → 140 bhp | ✓ |
| Peugeot 2008 1.6 BlueHDi 8V 100hp | 100 → 130 bhp | ✓ |
| Peugeot 2008 1.6 BlueHDi 8V 120hp | 120 → 150 bhp | ✓ |
| Peugeot 2008 1.6 BlueHDi 8V 75hp | 75 → 120 bhp | ✓ |
Year / chassis: 2013 - 2016
| Engine | Power | DPF fault solution |
|---|---|---|
| Peugeot 2008 1.4 e-HDI 68hp | 68 → 90 bhp | ✓ |
| Peugeot 2008 1.6 BlueHDi 8V 100hp | 100 → 130 bhp | ✓ |
| Peugeot 2008 1.6 BlueHDi 8V 120hp | 120 → 140 bhp | ✓ |
| Peugeot 2008 1.6 BlueHDi 8V 75hp | 75 → 120 bhp | ✓ |
| Peugeot 2008 1.6 e-HDi 8V 115hp | 115 → 140 bhp | ✓ |
| Peugeot 2008 1.6 e-HDi 8V 92hp | 92 → 115 bhp | ✓ |
Year / chassis: 2 - 2019+
| Engine | Power | DPF fault solution |
|---|---|---|
| Peugeot 2008 1.5 BlueHDi 130hp | 130 → 163 bhp | ✓ |
When is it needed?
- DPF full / regeneration warning
- Frequent regeneration and rising fuel use
- Engine warning light and reduced power
- Oil dilution and a costly DPF replacement
Typical duration: 1–2 hours
Frequently asked questions
Can a clogged DPF on the Peugeot 2008 be solved with software?
The filter and sensors are checked first; any mechanical fault is reported. Where suitable for the Peugeot 2008, the DPF software solution is applied to the ECU with the original software backed up and verified by a road test.
Will the car pass inspection after a DPF delete?
Work on emission hardware can affect inspection and road compliance. This work is offered only for uses permitted by law, such as off-road, motorsport, export or fault diagnosis. Inspection and road compliance remain the owner's responsibility.
Does the filter have to be physically removed?
We handle the software side; physical work on the filter is done in the workshop depending on the car and your choice. If only software is changed and the filter stays in place, it will keep loading up.
Should I try cleaning first?
In most cases yes. If the filter is not yet blocked, a forced regeneration or chemical clean is the better step; we measure the condition and tell you the cheapest route.
Will fuel consumption drop?
On a car that regenerates frequently it usually does, because the extra fuel burned during regeneration cycles disappears.
Other solutions for the Peugeot 2008
Peugeot 2008 AdBlue fault solution
Peugeot 2008 EGR fault solution
Peugeot 2008 Pop & Bang tuning
More about DPF Delete
Peugeot Stage 1 Chip Tuning — How Much BHP?
⚠ Software work on emission systems is offered only for uses permitted by applicable law (motorsport, off-road use, export, fault diagnosis, etc.). Road use and inspection compliance of the vehicle remain the owner's responsibility.